PROCEDURA DI CARICO/SCARICO

LOADING ONTO TRAILERS WITH LOADING RAMPS

Remove the ramp securing pins and slide the ramp onto the rear of the trailer.

Locate ramps on the back of the trailer using the captive location mechanism provided on the back of the trailer. Once fully located the ramp will not accidentally fall off the rear of the trailer during loading. Drive or winch the vehicle onto the trailer. Return the ramps to their original positions, and secure with pins provided. Ensure ramp is held under tension to eliminate rattling where possible.

LOADING ONTO TILT-BED, RAMPS FREE TRAILERS

Release the deck-to-’A’ frame securing clamps and close the valve on the hydraulic pump. Pump the hydraulic ram until the rear of the trailer touches the ground. Drive or winch the vehicle onto the trailer. Release the hydraulic valve gradually, making sure no one is under the trailer or in a position likely to result in injury by the lowering deck. Tighten the deck securing clamps.